PRONAR PRONAR N262, Руководство оператора

Страница: 78 / 145

Pronar N262 N262/1 SECTION 4
4.6
4.1.3 TEST START
If all the above activities have been performed and there is no doubt as to the good technical
condition of the spreader, the machine should be hitched to tractor according to instructions
specified in section 4.3 „HITCHING TO TRACTOR”. Start tractor engine, check all systems
and perform a test run of the manure spreader without load before beginning work. It is
recommended that the inspection is conducted by two people, one of which should always
remain in the tractor cab. Test start should be conducted according to the sequence shown
below.
Connect the manure spreader to appropriate hitch on agricultural tractor.
Connect PTO shaft and secure it in a proper manner.
Raise the parking stand.
Connect brake, electrical and hydraulic system conduits.
Check correct operation of lights and indicators.
Start tractor.
When moving off check if the main brakes operate correctly.
Check if the chain conveyor operates correctly.
If the hydraulic system is controlled from the tractor, start the chain
conveyor using the appropriate manifold lever in the tractor cab. Set
the conveyor speed by turning the knob of the flow regulator (item 1 -
figure (3.3) installed on the outrigger in the front section of the manure
spreader from position „0” to the maximum position „10” and check if
the feed direction is correct. Forward or reverse direction of movement
is selected using the appropriate selective control valve lever in the
tractor cab. Check if conduits are connected in a correct manner and if
flow regulator operates correctly.
If the hydraulic system is controlled from the manure spreader, start
the chain conveyor using the appropriate manifold lever installed on
the outrigger of the manure spreader conduits (Figure (3.8)). Using the
regulator knob, set the feed speed by shifting the knob from position
„0” to the maximum position „8” and check if the feed direction is