PRONAR PRONAR N262, Руководство оператора

Страница: 126 / 145

Pronar N262 N262/1 SECTION 5
5.32
turn off tractor engine and remove key from ignition,
secure tractor against unauthorised access,
disconnect hydraulic system lines,
disconnect PTO shaft connecting tractor and spreader
climb into the load box with due caution.
5.8 CLEANING
Carefully remove the remains of manure from the manure spreader daily after finished work.
It is recommended to do this using a pressure washer. In order to do this:
Open slide gate and tailgate.
Protect tailgate from falling down by closing the cut-off valve and with
a suitable mechanical support which is durable and stably mounted.
Mechanical support should be placed between tailgate and floor
conveyor strip.
Immobilise tractor and spreader with parking brake.
Place chocks under manure spreader wheel.
Turn off tractor engine and remove key from ignition.
Secure tractor against access of unauthorised persons.
Clean the manure spreader with strong water jet and leave to dry.
Using pressure washer increases washing effectiveness, but particular
care must be taken during work. During washing, washer nozzle may
not be closer than 50 cm from the surface being cleaned.
Using excessive pressure for cleaning may damage lacquer coating.
Do not direct water stream directly at system and equipment elements
of manure spreader i.e. control valve, braking force regulator, brake
cylinders, pneumatic, electric and hydraulic plugs, lights, electrical
connections, information and warning decals, identification plates, line
connections and lubrication points etc. High water jet pressure may
damage these elements.