PRONAR PRONAR N262, Руководство оператора

Страница: 77 / 145

SECTION 4 Pronar N262 N262/1
4.5
check if the nuts fixing the following components are properly tightened:
(wheels, drawbar hitching eye, spreading mechanism),
check oil level in the spreader unit transmission and in the feeding mechanism
transmission,
check tension of chain conveyor chain according to chapter 5.14,
check technical condition of PTO shafts, their shields and securing chains,
check the compliance of PTO parameters, termination type, speed,
make sure that the attached PTO shaft may be connected to the tractor (PTO
shaft should be suitable for the tractor – see the Operator's Manual of PTO
shaft),
check length of PTO shaft in the most favourable and difficult working
conditions,
check whether the PTO shaft pipes are sufficiently covered when the
widest angle is set between the tractor and the machine,
check whether the PTO shaft can be still slid when the smallest angle
is set (while turning),
check the PTO shaft length when driving up a hill (a steep slope).
ATTENTION
Pipe profiles of the PTO shaft must overlap at least at 1/2 of the length in normal working
conditions and at least at 1/3 of the length in all working conditions.
When adjusting the PTO shaft, follow the instructions presented in the Operator's
Manual of the PTO shaft.
When the tractor with the manure spreader are turning or travelling on an uneven terrain,
the PTO shaft may be damaged and/or destroyed if it is squeezed or disconnected as a
result of its wrong adjustment.
TIP
Adjustment of the PTO shaft applies only to a specific type of tractor. If the machine is
connected to a different type of tractor, the adjustment procedure for this type of tractor
should be possibly carried out.