Published: 18.07.2019
52 (63)
6.
Press the
Commission device
button.
7.
Press the
Re-open wireless project
button.
Existing network settings are displayed.
8.
Edit the device name if needed.
The device name is also used for the network name.
Note:
Don't use any special characters (ä, ö, å, :, [, etc.) in the device name.
9.
Press the
Next
button.
10.
Set the transmitter naming pattern.
Use ### to insert transmitter ID to the pattern.
11.
Press the
Next
button.
12.
Review the network configuration and press the
REBUILD NETWORK
button.
13.
Select the method to continue.
• Press
OK
button to return to main view.
• Press
Add transmitters to project
button to add wireless transmitters to network.
Important:
Configure all needed transmitter settings before connecting to the wireless
network.
The base unit deactivates the Bluetooth communication and moves to MIRA communication mode.
The wireless network is now visible in the
Wireless installation projects
view.
5.2.1 Removing devices from wireless network
1.
Reset the network settings in the devices that are going to remove.
See the chapter
on page 50 for more information.
2.
Connect Produal MyTool
®
to WBU.
3.
Press the
Commission device
button.
4.
Press the
Remove Transmitters
button.
5.
Select the devices to be removed from the network.
6.
Press the
REMOVE TRANSMITTERS
button.
7.
Press the
OK
button.
8.
Press the
REMOVE TRANSMITTERS
button.
The selected devices are now removed from the network.
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | [email protected]
Information is subject to change without prior notice.
EN - 5401comm