Published: 18.07.2019
24 (63)
Parameter name
Values
Default
Description
Address of register
cloned from WTR, slot
7
See the
following table.
Input 3
The transmitters' value to be cloned to slot 7.
The values are cloned to base unit registers
18600...18699.
Address of register
cloned from WTR, slot
8
See the
following table.
Input 4
The transmitters' value to be cloned to slot 8.
The values are cloned to base unit registers
18700...18799.
Address of register
cloned from WTR, slot
9
See the
following table.
Battery level
The transmitters' value to be cloned to slot 9.
The values are cloned to base unit registers
18800...18899.
Address of register
cloned from WTR, slot
10
See the
following table.
Signal strength
The transmitters' value to be cloned to slot 10.
The values are cloned to base unit registers
18900...18999.
Parameter value
Description
Temperature
Temperature measurement.
Humidity
Humidity measurement.
Transmitter specific
measurement 1...3
Transmitter specific measurements (e.g.
Transmitter specific value 1
= CO
2
measurement).
Input 1...4
Inputs' values.
Battery level
Transmitter battery level.
Signal strength
Transmitter signal strength.
4.4 Configuring Value Over Bus settings
You can configure up to three Value Over bus functions.
1.
Press the
Value Over Bus
button in the
Configurations
view.
2.
Select the configuration you are going to set by pressing the number.
3.
Make the settings.
See the chapter
Available settings for value over bus
on page 24 for more details.
4.
Press the
Confirm changes
button to save the changes.
5.
Press
Install to device
button to write the changes to the device.
4.4.1 Available settings for value over bus
Parameter name Values
Default
Description
Bus mode
Global type and
value / Global type,
individual values
Global type and
value
Alarm for offline transmitters. Set the offline time
that activates the alarm.
Bus value type
No value /
Temperature / ...
No value
See the available values and their descriptions
from the chapter
Available value over bus (VOB)
on page 38.
4.5 Configuring communication settings
1.
Press the
Communication
button in the
Configurations
display.
2.
Make the settings.
See the chapter
Available settings for communication
on page 25 for more details.
3.
Press the
Confirm changes
button to save the changes.
4.
Press
Install to device
button to write the changes to the device.
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | [email protected]
Information is subject to change without prior notice.
EN - 5401comm