Published: 18.07.2019
49 (63)
8.
Press the
Commission device
button.
Important:
Configure all needed transmitter settings before connecting to the wireless
network.
Configuring the wireless transmitters
on page 53 for more information.
9.
Press the
Network installation
button.
If the
Network installation
button is not visible, the device is already connected to a network.
You have to reset the network settings to be able connect the device to a new network. See the
on page 50 for more information.
10.
Select manual or automatic ID for the device.
When selecting the manual ID, there are few things to be considered.
• The ID can be 1...100.
• The ID must be unique inside the network.
• If the ID is already used inside the network, the application asks to replace the existing device.
The existing device is disconnected from the network if replaced.
If you select automatic ID generation, the base unit gives the ID's to the devices when they
connect to the network.
Note:
The transmitters may join to the network in different order than they are
commissioned. Therefore, if you want specific ID's to certain devices, it is recommended
to use manual ID.
11.
Press the
Next
button.
12.
Write the device name.
The application warns about names that are already used during the same commissioning session.
Note:
Don't use any special characters (ä, ö, å, :, [, etc.) in the device name.
13.
Press the
Next
button.
14.
Review the network configuration and press the
INITIALIZE NETWORK
button.
15.
Press
OK
button on the
Configuration finished
view.
The base unit deactivates the Bluetooth communication and moves to MIRA communication mode.
MyTool returns to the
Transmitter Scan
view.
Note:
The transmitter tries to connect to the network immediately. If the first
connection attempt fails, the transmitter tries to connect again in the following schedule:
1, 2, 4, 8, 16, 32, 64, 128 min. If the network connection fails after 128 minutes, the
transmitter restarts and starts the connecting procedure from the beginning.
16.
Add more devices if needed.
17.
When all needed devices are added, press the
End installation
button.
18.
If needed, save the network settings to a .csv file by pressing the
Export installation report
button.
19.
Press the
End installation
button.
20.
Press the
Close project
button.
Note:
When installing transmitters to network or when the transmitters have lost the
connection, it can take several minutes before the transmitters are connected to network.
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | [email protected]
Information is subject to change without prior notice.
EN - 5401comm