Proceq ZAA 2600.C, Инструкция по эксплуатации

Страница: 46 / 52

Page 46
If the device has to be disinfected, do not use disinfectants that contain
sodium hydroxide.
12.3 Lubrication of the guide rods
After a service performance of about 2’000 km a message will appear at start-up
reminding you of lubricating the guide rods. The guide rods have to be lubricated
latest if this message appears or at least once per year.
Before lubricating the guide rods of the Proceq ZAA 2600, always switch off
the apparatus and unplug it.
No oil shall be sprayed into the apparatus. The function of electrical or
mechanical components could be impaired.
For lubricating proceed as follows:
•
Remove the glass plate (3) (see chapter 11
“Turning the glass plate” on page
45).
•
Loosen the fixing screws of the side panels (16) and remove the side panels
(15).
•
Turn the apparatus carefully to one side so that the side opening of the cover
becomes accessible.
•
Put some drops of sewing machine oil on your finger and spread it over the
whole length of the guide rods.
•
Repeat this for the other side of the apparatus.
•
Adjust the start stop (1) at the very beginning and the end stop (2) at the very
end and move the tool holder (18) back and forth several times, so that the oil
gets evenly distributed over the whole length of the rods.
•
Remount the side panels (15) and replace the glass plate (3).