Primus D11, Руководство по обслуживанию

Страница: 42 / 160

40
70284701
Section 6 Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
54. LOADING DOOR SWITCH
The door switch should be adjusted so the cylinder
stops when door is opened 2 inches (51 mm), plus
or minus 1/4 inch (6 mm). The switch is normally
open and is closed when the door is closed. If
adjustment is needed, proceed as follows:
a. Close door and start tumbler. Slowly open
loading door. Cylinder and heat system should
shut off when door is open 2 inches (51 mm),
plus or minus 1/4 inch (6 mm).
b. Slowly close loading door. When door is 2
inches or less from being fully closed, the
switch actuator on the door should contact the
switch plunger and depress it enough to close
the switch with an audible “click”.
If tab does not depress the switch plunger
enough to operate the switch, bend tab on
loading door OUTWARD and repeat steps “a”
and “b.”.
EUROPEAN MODELS (Prior to Serial
Number 0208002174)
European tumblers, prior to Serial Number
0208002174, have a second door switch near the
top of the door. Refer to Figure 30. This switch
also should be adjusted so the cylinder stops when
door is opened 2 inches (51 mm), plus or minus
1/4 inch (6 mm). This switch is normally closed
and is opened by the hinge cam when the door is
opened. If adjustment is needed, proceed as
follows:
a. Remove switch actuator so door switch click
can be heard.
b. Loosen door switch screws just enough so
switch can be moved left or right. Move door
switch right if door opens too far before switch
clicks. Move door switch left if door doesn’t
open far enough before switch clicks.
c. Retighten door switch screws and retest. Repeat
step “b” if further adjustment is needed.
d. Reinstall switch actuator.
Figure 30
T275SE1B
EUROPEAN DOOR
SWITCH
DOOR SWITCH
SCREWS
SWITCH
PLUNGER
SWITCH
ACTUATOR
DOOR