28
User Guide
Using Walk-and-Talk products
8. To project your computer on the WT or WTL whiteboard so you can
navigate documents, presentations, or websites, press the
Projection button on the remote. (Refer to "Using Walk-and-Talk in
projection mode" on page 30.)
9. To toggle between cursor control or writing in projection mode, press
the Pen/Cursor button on the remote control. (Refer to "Cursor
control in projection mode" on page 37.)
10. To annotate the computer projection on the whiteboard, write with
your finger over the computer projection. (Refer to "Writing in
projection mode" on page 39.)
11. To navigate the computer from the whiteboard, use your finger as
the mouse on the whiteboard. (Refer to "Cursor control in projection
mode" on page 37.)
12. To navigate the computer using the remote control, use your finger
on the touch pad. (Refer to "Cursor control in projection mode" on
page 37.)
note:
NOTE:
The Walk-and-Talk IP always operates in projection mode using a stylus.
PolyVision driver installation for Walk-and-Talk products
If the PolyVision driver is not installed on the computer you want to use with
Walk-and-Talk, install the driver.
The PolyVision driver is always close at hand. You need no installation disk
or CD-ROM. Installing the PolyVision driver takes place when you connect
the PolyKey on the Walk-and-Talk USB cable to your computer’s USB port.
Your Windows-based computer must have:
Ŗ
Windows 2000, XP, Tablet XP, or Vista
Ŗ
VGA HD-15 video port for projectors or interactive panels
Ŗ
One USB port (two for the interactive panel)
Your Macintosh computer must have:
Ŗ
PowerPC G3 or higher or Intel-based processor
Ŗ
Mac OS 10.2 or higher
Ŗ
VGA HD-15 video port for projectors or interactive panels
Ŗ
One USB port (two for the interactive panel)
9A67)DQQMHO2CIG(TKFC[,WPG#/
