PRV-9000 Operating Instructions
seconds behind the actual time so adjust the timer program for this slippage.
When the signal ceases, the recorder stops recording.
Follow the directions below to record from a satellite tuner or other device.
1. Set the timer on the satellite tuner.
Refer to the device’s operating instructions for assistance.
2. Switch the satellite tuner’s power to OFF (or in to Standby).
3. Load a recordable disc in to the recorder.
4. Verify Audio In options are at the desired settings.
For more information, refer to Chapter 9:INITIAL SETTINGS MENU,
section
9.1.5
Audio In Settings.
5. Press
REC MODE
to set the recording mode.
Refer to Chapter 4: GETTING STARTED, section 4.10 Initializing
Recording Modes.
6. Press and hold
FUNCTION
on the recorder’s front panel for
approximately three seconds.
The recorder returns to Standby and the AUTO REC indicator lights.
The recorder turns ON then OFF in sync with the satellite tuner.
The auto-start function is unavailable in the following situations:
recorder is already recording a program
loaded disc is full or other than recordable media
loaded disc is protected
loaded disc already contains the maximum number of titles (99)
another timer recording program is already in progress
timer program supercedes a auto-start program
auto-start automatically launches after the timer program is complete
6.3.4 Record From the DV Output Port
To record from a non-copy-protected DVD disc to a camcorder, use the DV
IN/OUT port on the recorder’s front panel. Follow the directions below to
record from a disc to a camcorder.
1. Connect the camcorder to the DV IN/OUT port.
2. Load the source disc.
3. Scan to the segment to be recorded.
86