PSEN op2H-SL Series
Operating Manual PSEN op2H-SL Series
1004304-EN-01
28
Attach safety light grids using L and C-brackets
Detailed view of the L-bracket, non-connection end
[1]
[2]
[3]
[4]
[5]
Legend
[1] Vertical section of L-bracket
[2] Horizontal section of L-bracket
[3] M3 screw to attach the horizontal section of the L-bracket to the vertical section
[4] M4 screw to attach the vertical section of the C-bracket
[5] Slotted hole washers
1. Make two drill holes in the mounting surface for the L-bracket at the connection end as
shown [1] and install the vertical section and horizontal section of the L-bracket [2].
Tighten all screws to 1,2 Nm.
2. Make two drill holes in the mounting surface as shown [1] and install the C-bracket [2].
Tighten the M4 screws to 1,2 Nm.
3. Slightly loosen the M3 screw [3] on the C-bracket and open the C bracket's clamping
jaws.
4. At a slight angle, insert the transmitter/receiver into the C-bracket [4]. Use the corres-
ponding longitudinal slot on the profile.
5. Turn the transmitter/receiver until you reach the anchor of the upper jaw [5].
6. Insert the transmitter/receiver into the L-bracket as far as it will go.
7. Tighten the M3 screw on the C-bracket to 1,2 Nm. [6]
