Pepperl+Fuchs F2D0-MIO-Ex12.PA Series, Руководство пользователя

Страница: 32 / 105

2
0
1
8
-0
7
32
Multi-Input/Output Device
Configuration
The coding of the status is as follows:
ROUT_D
The variable ROUT_D consists of 2 bytes providing the setpoint value of the valve which is re-
transferred by RIN_D for monitoring and the status. This setpoint value does not include
information of the states of the position feedback sensors. The status is mainly used to control
the sequence of module change in case of failure.
The coding of the status is as follows:
Classic Status Value Mnemonic Description
0x80 GOOD (NC)-OK Feedback value valid.
0x84 GOOD (NC)-UE (Update event.)
10-s message for parameter changes.
0x0C BAD (NC)-DF (Device failure.)
Electric hardware fault. Send the device to
Fuchs for repair.
0x10 BAD (NC)-SF Position feedback sensor combination not
allowed.
0x11 BAD (NC)-SF Lead short circuit
0x12 BAD (NC)-SF Lead breakage
Classic Status Value Mnemonic Description
0xC0 GOOD (C)-OK Valid setpoint value.
0xC2 GOOD (C)-IR (Initialization request.)
Clearance request from slave to master in
order to change to the RCas mode.
0xCC GOOD (C)-NI (Not invited.)
RCas is not set as the target mode.
0x0C BAD-DF (Device failure.)
Electric hardware fault. Send device to
Fuchs for repair.
0x1C BAD-OS (Out of service.)
Is set in the OoS mode.