11
Network settings
Network settings of the recorder
Configure the following settings for the ports to be used.
The following settings can be configured using the buttons on the front panel. Parameters will be displayed on the
LCD.
Setup items
Description
DHCP
Determine whether or not use a DHCP server. Select "ON" to obtain an IP address,
subnet mask and default gateway from a DHCP server.
IP address
When selecting "OFF" for "DHCP", enter an IP address.
Subnet mask
When selecting "OFF" for "DHCP", enter a subnet mask.
Default gateway
When selecting "OFF" for "DHCP", enter a default gateway.
HTTP port
Designate the HTTP port number to be used. Normally "80" is to be designated.
The default network settings of the recorder are as follows.
Setup items
Camera port
Client PC port
Maintenance port
DHCP
–
OFF
–
IP address
192.168.0.250
192.168.1.250
192.168.2.250
Subnet mask
255.255.255.0
255.255.255.0
255.255.255.0
Default gateway
–
192.168.1.1
–
HTTP port
–
80
–
Important:
• The network settings for each port (IP address, etc.) should be configured with a different subnet. Otherwise,
network communication may be failed.
Note:
• When the network settings of the PC are as follows, it is unnecessary to configure the above settings. It is pos
-
sible to configure the settings and operate the recorder using a web browser after completing the connection.
IP address:
192.168.1.2 to 249, 192.168.1.251 to 254
Subnet mask:
255.255.255.0
Default gateway:
192.168.1.1
When the settings values other than above are set, it is necessary to configure the network settings of the
recorder and the PC.
• The network settings of a camera can be configured on the setup menu of the camera. Refer to the "NW cam
-
era" section on page 49 for further information.
