Panasonic VR2 Series, Руководство по эксплуатации, Страница: 191 / 236

16-35
16-9-5. WFACC
Format WFACC [Acceleration]
Function It specifies acceleration time of wire feeding. Acceleration Acceleration time:
Condition Using TIG-FORCE. [0.10 – 0.99] s
Lock condition Arc lock (Internal execution)
Syntax check None.
Example WFACC 0.5
16-9-6. WFDCC
Format WFDCC [Deceleration]
Function It specifies deceleration time of wire feeding. Deceleration Deceleration time:
Condition
Using MIG,MAG
､
TIG-FORCE.
[0.10 – 0.99] s
Lock condition Arc lock (Internal execution)
Syntax check None.
Example WFDCC 0.5
16-9-7. WFEED
Format WFEED [Condition]
Function It starts or stops wire feeding. Condition
Condition
Using MIG,MAG
､
TIG-FORCE.
Lock condition Arc lock (Internal execution)
Syntax check None.
Stop : Stop
Forward on: Start wire feed to
forward direction.
Reverse on : Start wire feed to
reverse direction.
Preset FWD : Start forward wire
feed by preset amount with the
WFLENGTH command.
Preset RVS : Start reverse wire
feed by preset amount with the
WFLENGTH command.
Example
WFEED Preset FWD
Note Wire is fed with LOW speed when the feed speed is not specified.
16-9-8. WFSLDN
Format WFSLD =[Speed] m/min
Function It specifies wire feed speed from the arc start to
the arc generation. Speed
Condition
Wire feed speed
Range: [0.1 – 2.5 m/min]
Lock condition Arc lock (Internal execution)
Syntax check None
Example Set the wire feed speed at arc start to 1.5 m/min.
WFSLDN 1.5
The same command in
conventional models
Note * Please refer to section “Input of sequence commands” in the operation manual (OM0205052JE) of
push pull welding torch (YT-MBT501T**/YT-BMT501Y**).