Panasonic VR2 Series, Руководство по эксплуатации, Страница: 170 / 236

16-14
16-5. Welding commands(GMAW and common use)
16-5-1. ADJRST
Format ADJRST
Function To reset welding process fine adjustment to default values.
Condition Weld package.
Lock condition Arc lock (Internal execution).
Syntax check None.
Example ADJRST The same command in conventional models ADJRST
Values to be reset are those changed from their default values using the following sequences.
BBKTIME FTTLVL HOTCUR HOTVLT IAC
IB2
INIT-IB INIT-IP I-PFALL I-PRISE
ISC ISL1 ISL2 PFALL P-HOTTM
PPEAK PRISE TSO TSP WIRSLDN
16-5-2. AMP
Format
AMP [Amperage]
Function Welding current setting. Amperage Welding amperage [1 - 999] A
Condition Weld package.
Lock condition Arc lock (Internal execution, specify values).
Syntax check None.
Example Sets welding amperage to 200A.
AMP=200
The same command in
conventional models AMP
16-5-3. ARC-OFF
Format ARC-OFF [File name] RELEASE=[Table]
Function It ends the welding operation File name Name of the weld end operation file.
Condition Weld package.
Lock condition Arc lock (Internal execution).
Syntax check The specified file name does not exist.
Table Table number to execute
automatic stick release. [0 - 5]
Input “0” for no stick release.
* Note) As for built-in welding power source
controller, the table #6 and #7 are
available, which is to retract wire
automatically when the stick release
functions.
Example Execute ArcEnd1 file to end welding operation.
ARC-OFF ArcEnd1
The same command in
conventional models AES
16-5-4. ARC-ON
Format ARC-ON [File name] RETRY=[Table]
Function It starts welding operation
Specify the file name for a series of torch ON
operation which has been store in another file.
The sample file using file name ArcStart1-5 is
set at shipment.
File name Name of the file for weld start
operation.
Condition Weld package.
Lock condition Arc lock (Internal execution).
Syntax check The specified file name does not exist.
Table Table number to execute arc retry.
[0 - 5]
Input “0” for no arc retry.
Example Execute ArcStart1 file to terminate welding
operation. Do not apply the arc retry function.
ARC-OFF ArcStart1 RETRY=0
The same command in
conventional models ASS