78
English
Note
●
When this function is set to [DIGITAL LINK], set
[Quick start] to [On] to enable the operation.
●
When [Quick start] is set to [Off], if this function is set
to [DIGITAL LINK], the unit is controlled via DIGITAL
LINK in power-on state while controlled with the
SERIAL IN terminal in standby state. To enable the
DIGITAL LINK control even in standby state, it is
necessary to set [Quick start] to [On].
■
[Auto display name]
Sets whether to change the display name automatically.
[Off]:
The display name is not changed automatically.
[On]:
Changes the display name automatically in
accordance with the set point of the display ID.
■
[Display name]
The name of the Display that is shown on the network
can be changed.
Note
●
The name can be changed only when [Auto display
name] is set to [Off].
●
Display ID is not reset to default with [Network
settings] - [Reset].
■
[USB memory network settings]
Sets whether to permit the network setting using the
USB memory device. (see page 131)
[Permit]:
Permits USB memory network settings.
[Prohibit]:
Prohibits USB memory network settings.
Note
●
This function is set to [Permit] as factory default.
●
Once the network setting is done with USB memory
device, this function is set to [Prohibit].
■
[LAN control protocol]
Select the LAN control protocol.
[Protocol 1]:
Control with the Panasonic Display sequence.
[Protocol 2]:
Control with the sequence that is compatible with
Panasonic Projector.
Note
●
For PJLink and WEB browser control, the operation is
possible regardless of the setting.
●
When operating the “Multi Monitoring & Control
Software”, select [Protocol 2].
■
[Reset]
You can reset the network setting to the factory default
of the Display.
Select [Yes] with and press <ENTER>.
Network settings
Reset
Yes
No
Note
●
The settings for [NTP synchronization], NTP server
and [Time zone] will be reset to the factory default.
●
When [Security password] - [Security password] is set
to [On], it is necessary to input the password when
commanding [Reset].
