Panasonic PV-500, Руководство пользователя

Страница: 379 / 494

377
O
pe
ra
tio
n a
n
d D
a
ta
O
ut
put
t
hr
ou
gh I
/O
T
e
rm
ina
ls
C
h
ap
te
r 8
INDE
X
Cause
Error
Code
Solution, etc
When switching layout;
• Although PV500 is operating (RUN), displaying SETUP
menu cannot switch layout.
E0245 Switch to RUN menu,
• Other number than 00-31 is specified for layout number.
• No layout has been registered in the specified layout
number.
E0246 Specify a correct layout number.
When sending parameter write command (%PW, %PWP);
• Because PV500 shows SETUP menu, parameters
cannot be written.
E0250 Switch to RUN menu.
• Specification of the parameter is wrong.
(e.g. Undefined parameter is specified.)
E0251 Specify correct parameters.
• The specified parameter does not exist. (e.g. The
number of uncreated checker is specified as a
parameter.)
• The specified parameter value is out of the settable
range. (e.g. Maximum value of slice level is being set to
over 256.)
• The specified values led to the status of “Maximum
value < Minimum value” when entering them.
• When specifying the moving distance of the marker, a
part of the circumscribing rectangle of the marker (the
intersection point when Shape is Cross line) after
move was out of the nine screens where checker area
is settable.
E0252
• When the number of write commande received by
PV500 exceeds the receivable number when
executing one inspection.
E0253 Decrease commands to send to
PV500.
When outputting the latest inspection image to a SD memory card or Ethernet interface(Output Latest Image);
• No SD memory card is attached, the card cannot be
accessed, or used up its capacity.
• The SD memory card is write-protected.
E0255 Correctly attach a SD memory
card which is writable and has
enough free space.
• Output Condition* of Image Output is not set to
[Command Reception].
*"ENVIRONMENT" > "Input/Output" > "Image Output" >
"Output Conditions"
E0256 Set Output Condition to
[Command Reception].
• There is no image captured.
E0257 Capture an image.
When saving Image memory of PV500 in a SD memory card;
• No SD memory card is attached, the card cannot be
accessed, or used up its capacity.
• The SD memory card is write-protected.
E0260 Correctly attach a SD memory
card which is writable and has
enough free space.
When saving Image memory of PV500 in a SD memory card,
there is no blank folder. (All of 00-99 are used.) Delete all or some folders of 00 -
99 in the “Backup” folder of the
SD memory card.
• No image is saved in the image memory.
When saving Print screen in a SD memory card or a PC through Ethernet;
• No SD memory card is attached, the card cannot be
accessed, or used up its capacity.
• The SD memory card is write-protected.
E0265 Correctly attach a SD memory
card which is writable and has
enough free space.
• Ethernet communication cannot be established (with
connection problems such as cable unconnected or
disconnection).
• Image Receiver is not activated.
E0266 Correctly connect Ethernet.
Activate Image Receiver, and set
it to "CONN: Standby".
When sending the command prohibiting/permitting keypad operation
• The command was sent in SETUP MENU.
E0270 Switch to RUN menu.
• Specification of the parameter is wrong. Other number
than 0 and 1 is specified.
E0271 Specify correct parameters.