Panasonic PT-RZ16K, Инструкция по эксплуатации (Функциональное руководство)

Страница: 64 / 277

Chapter 3 Basic Operations — Switching on/off the projector
64 - ENGLISH
Relationship between brightness and runtime
The projector can be operated with arbitrary brightness and runtime by setting [LIGHT OUTPUT] to desired
setting.
The relationship between the [LIGHT OUTPUT] setting, brightness, and the estimated runtime is as follows. Make
the initial setting (operation setting) depending on the desired brightness of the projected image and runtime.
The values of the brightness and the runtime are just an estimate, and the graph indicating the relationship is just
an example. Also, these do not indicate the warranty period.
[LIGHT OUTPUT] (%) Brightness (lm) Estimated runtime
*1
(hours)
100.0 16 000 24 300
90.0 14 400 26 600
80.0 12 800 29 400
70.0 11 200 32 700
60.0 9 600 36 900
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
3
dust.
Estimated runtime (hours)
36 800 34 300 31 800 29 300 26 800 24 300
50.0
9 600
60.0
[LIGHT OUTPUT] (%)
Brightness (lm)
70.0
80.0
90.0
16 000
100.0
Note
f
Under influence of characteristics of each light source, conditions of use, installation environment, etc., the runtime may be shorter than the
estimation.
f
If the consolidated runtime of the projector exceeds 20 000 hours, replacement of the components inside the projector may be required. The
consolidated runtime can be confirmed in the [STATUS] screen. Refer to the [PROJECTOR SETUP] menu → [STATUS] for details.
f
After completed the initial setting, the wider the combination of luminance and runtime becomes by setting the [PROJECTOR SETUP]
menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [CONSTANT MODE] to [AUTO] or [PC]. Refer to the
[PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] for details.