Chapter 2
Getting Started — Connecting
54 - ENGLISH
f
The projector does not support VIERA Link (HDMI).
f
It is necessary to switch the setting in the [DISPLAY OPTION] menu
→
[RGB IN]
→
[RGB1 INPUT SETTING] (
x
page 128) when inputting
a video signal and the Y/C signal.
For <SDI IN 1>/<SDI IN 2> terminals
SD-SDI signal, HD-SDI signal, or 3G-SDI
signal
Digital VCR for commercial use
Note
f
Use a 5C-FB or higher (such as 5C-FB, or 7C-FB) or a Belden 1694A or higher connection cable to properly transmit images. Use a
connection cable of 100 m (328'1") length or less.
f
Setting of the [DISPLAY OPTION] menu
→
[SDI IN] may be necessary depending on the connected external device.
f
To input the dual link signals, setting the [DISPLAY OPTION] menu
→
[SDI IN]
→
[SDI LINK] is required.
f
To input the dual link signals, the cables to connect to the <SDI IN 1>/<SDI IN 2> terminals should be the same length and the same type.
The image may not be displayed correctly when the difference of the cable length is 4 m (13'1") or more.
f
Directly connect the projector with the external device that will output the signal without going through a distributor, etc., when inputting dual
link signals. A phase difference is generated between the Link A signal and the Link B signal, and the image may not be projected correctly.
f
An error in signal detection may occur when an unsteady signal is connected. In such case, set the [DISPLAY OPTION] menu
→
[SDI IN] to
the content corresponding to the input signal.
Connecting example: Computers
Control computer
Computer
Computer
Computer
Computer
Control computer
Attention
f
When connecting the projector to a computer or an external device, use the power cord supplied with each device and commercially
available shielded cables.
Note
f
Switching of the setting in the [DISPLAY OPTION] menu
→
[DVI-D IN]
→
[EDID SELECT] may be required depending on the connected
external device when DVI-D is input.
f
For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. If a cable that does not conform to the HDMI
standards is used, images may be interrupted or may not be displayed.
f
The <HDMI IN> terminal of the projector can be connected to an external device equipped with a DVI-D terminal using an HDMI/DVI
conversion cable. However, this may not function properly for some external devices, and images may not be displayed.
f
The <DVI-D IN> terminal supports single links only.
f
When entering the SYNC ON GREEN signal, do not enter sync signals to the <SYNC/HD> terminal or the <VD> terminal.
f
If you operate the projector using the computer with the resume feature (last memory), you may have to reset the resume feature to operate
the projector.
Содержание PT-RZ16K
Страница 58: ...58 ENGLISH Chapter 3 Basic Operations This chapter describes basic operations to start with ...
Страница 198: ...198 ENGLISH Chapter 5 Operations This chapter describes how to use each function ...
Страница 239: ...ENGLISH 239 Chapter 7 Appendix This chapter describes specifications and after sales service for the projector ...