Panasonic AJ-YA120AG, Руководство по обслуживанию

Страница: 387 / 647

DIS-2
3. Unscrew the four screws (E) and (F), and then
slowly lift up the Front Loading Unit.
1-5. Removal of Rear Jack Panel
1. Unscrew the six screws (G) and (H).
2. Disconnect the three connectors (P4101, 4130,
4303).
3. Remove the Rear Panel.
Note :
When the Optional Board AJ-YA120AG is
installed, perform steps 4 to 5.
4. Temporally remove the SGEN_SDI Board and
then unscrew the three screws (I), and remove
the connector support angles.
5. Disconnect the four connectors [SD OUT1
(Black), SDI IN (gray), OUT1 (Brown) and OUT2
(Blue)].
Note: When the Optional Board AJ-YA120AG or
AJ-YAD120AG has been installed, perform step
6.
6. Unscrew the tree screws (J) and temporally
remove the Connector Panel.
7. Open the Rear Panel and remove the SDI cables,
and Connector Panel of AJ-YA120AG.
8. Unscrew the two screws (K) and remove the
IEEE1394 Connector Unit of AJ-YAD120AG from
the Rear Panel.
Note: 1. Pay attention not to damage the cable and
wires.
2. Perform assembly by reversing the
procedure.
(F) (F)
(E)
P4103
P4303
P4101
(I)
SD
OUT 1
(Black)
SDI IN
(Gray)
OUT 1
(Brown)
OUT 2
(Blue)
(H)
(H)
(G)
(J)
(K)
Part of
AJ-YA120A
Part of
AJ-YAD120A