Panasonic AJ-YA120AG, Руководство по обслуживанию

Страница: 293 / 647

MECH-23
1-33. LISTA Sensitivity Adjustment and Detection (SD)
TP
TP405 : ATF ERR RPL/TRL
(RF/EQ Board: Slot 1)
TP4 : TR L HSW
(RF/EQ Board: Slot 1)
TG1 : GND (RF/EQ Board: Slot 1)
ADJ.
(ATF GAIN)
Service menu: A11: RPL GAIN 50
MODE
PLAY
LISTA
AJ-HD1500 [50M: 9000rpm]
TAPE
VFM3581KM or
VFM3581KL [DVCPRO LISTA]
SPEC.
100 ± 10 mV/um
<Sensitivity Adjustment Procedure>
1. Select the “<1> AJ-HD1500” [50M: 9000rpm] on
the LISTA software.
2. Connect the LISTA cable to the Test Points.
3. Open the SERVO ADJUST menu and select
“A11: TRL GAIN 50”.
4. Play back the LISTA Alignment Tape.
5. Select the item “<6> ATF Error Signal Monitor” on
the LISTA main menu, and when message “1.2%
Speed….” appears, press the Enter key.
6. Adjust EVR so that the “Sens. Value 1” on the
upper right corner of the screen is within the
specification.
7. After the adjustment, press the ESC key to return
to the main menu.
<Sensitivity Detection Procedure>
1. Open the SERVO ADJUST menu.
2. Select A11: RPL GAIN 50.
3. Play Back the LISTA Alignment Tape.
4. Select the item “<1> Sensitivity Measurement” on
the LISTA main menu, and then “1.2% Speed. . .”
appears on the screen. Press the Enter key, and
then start measurement of the sensitivity value.
5. Confirm the sensitivity value is within the
specification, when the message <<Sensitivity
Measurement Finish>> and “Sensitivity =
Sensitivity Value” are displayed on screen.
6. If it is out of specification, repeat the step item 3,
4 and 5.
7. If still out of specification, execute the “Sensitivity
Adjustment” again.
To be changed
<<< 50M Mode ATF Error Signal Waveform >>>
<<< Differential Data >>>
Sens. Value: 103.62 mV/um
Sens. L1: 102.36 mV/um
Sens. L2: 104.88 mV/um
Cancel: Hit any key
<< Sensitivity Measurement Finish >>
Sensitivity (50M) 103.62 (mV/um)
Sens. L1
102.36 (mV/um)
Sens. L2 104.88 (mV/um)
Measurement Result