Palamides 102-13, Руководство по эксплуатации

Страница: 55 / 68

Code list TC161
14
Subject to change without notice
55
Code-
Nr. Password
protected Set
value Limit
- Limit
+ Unit Title Description
116 yes 50 0 Direction counter 5 In stream delivery mode, this is the maximum the belts move the
sheet forward as it arrives. The distance is calculated from the
calibrated value. Standard value is 50% of the calibrated sheet
length.
117 yes 50 0 200 in % of the
sheet length Max. distance Maximum distance of the deflector before a reaction has to occur.
118 yes 259 0 mm Direction counter 6 In stream delivery mode, the start is triggered by photocells
B8/B9/B11. The transport belts start after this value has elapsed
119 no 0
1
2
3 0 3 Language 1
Language 2
Language 3
Language 4
German
English
Dutch
120 no 0 Photocell on the sheet run 0=all, 1=B8, 2=B11, 3=B9
121 yes 2000 1000 5000 ms Delay 16 Welding time monitoring. If the heating dies are heated for a long
time, the machine stops with error 18.
122 no 20 20 5000 ms Delay 6 After reaching the pre-selected batch piece value, the elevation
table moves into the intermediate position and stops after photocell
B18 is released. Photocell B18 must remain free for at least this
period of time before the elevation table stops.
123 no 300 0 10000 ms Delay 7 After reaching the intermediate position, the elevation table moves
upwards until press sensor B5 responds. This is the maximum
value during which it moves up. After this value, the elevation table
is stopped and the welding process is triggered independently from
B5.
124 no 1500 ms Delay 8 Only in connection with the option "Batch level compensator".
Usually, the batch level gates are set so that they retract when they
reach the intermediate position. This retraction can be delayed by
increasing this value.
125 yes 1500 ms Delay 9 After activation, the pressing guides must be extended at the latest
after this length of time (B3). If not, the machine will stop with Error
16.
126 no 1 Running out of banding, the machine stops with Error 42 (see also
code 127).