PairGain PG-Flex, Руководство пользователя

Страница: 40 / 168

Installing PG-Flex System Hardware
32
Connect the Subscriber Lines
To install subscriber lines for the FRE-765 List 4A enclosure do the following:
1 Route the subscriber line cables through the bottom of the enclosure.
2
Terminate the cables per Table 11.
3 Secure with a cable tie to the bracket near the cable entrance.
* For the FRE-765 List 4A RT Enclosure, the cable on the rear of the AMP Quiet Front
termination module is installed in connector P1 on the RT enclosure backlane.
† Shaded terminations are used only with 8 Channel POTS or 4 Channel DDS Units.
Do not connect metallic bypass pairs between PG-Flex systems or to other digital loop carrier
(DLC) systems.
Table 11. Subscriber Terminations for List 4A (12/24 channel systems)
* †
Subscriber Protector
Channel Unit Circuit Connector Pair Strip Socket
1 TB1 1 PB1 1
2 TB1 2 PB1 2
3 TB1 3 PB1 3
1 4 TB1 4 PB1 4
5 TB1 5 PB1 5
6 TB1 6 PB1 6
7 TB1 7 PB1 7
8 TB1 8 PB1 8
1 TB1 9 PB1 9
2 TB1 10 PB1 10
3 TB1 11 PB2 1
2 4 TB1 12 PB2 2
5 TB2 1 PB2 3
6 TB2 2 PB2 4
7 TB2 3 PB2 5
8 TB2 4 PB2 6
1 TB2 5 PB2 7
2 TB2 6 PB2 8
3 TB2 7 PB2 9
3 4 TB2 8 PB2 10
5 TB2 9 PB3 1
6 TB2 10 PB3 2
7 TB2 11 PB3 3
8 TB2 12 PB3 4