ORTECO IIa Series, Руководство по эксплуатации и обслуживанию

Страница: 34 / 114

UN21-0160EI
U
R S
A
D E F G H L
M
P
B
N
Q C1 C2 C
T
28
English language Use and maintenance
INFORMATION FOR USE
6
Dashboard controls (base version)
The controls of any accessory installed on the machine are described in the use procedures
of each single accessory.
A) Disconnecting switch to isolate the batteries: to disconnect and connect the battery
to the electrical system.
B) Ignition switch: to switch on the engine.
C) Multifunction signalling instrument: this shows the engine rpm (C1) and the number
of hours of operation (C2).
D) Signal light (red): this indicates the state of operation of the alternator. When the light
is on, it means the alternator is not charging the battery.
E) Signal light (red): this shows there is insufficient engine oil pressure.
F) Signal light (red): this shows that the engine air filter is clogged.
G) Signal light (red): this shows the engine is overheating.
H) Signal light (orange): low fuel warning light.
L) Signal light (red): this shows that the delivery filter of the hydraulic system is clogged.
M) Area without control device.
N) Buzzer.
1) A continuous sound signal warns that the oil pressure is insufficient. The engine
switches off automatically and the signal lights (D) and (E) switch on.
2) A continuous sound signal warns that the emergency button has been pressed. The
engine switches off automatically and the signal lights (D) and (E) switch on.
3) An intermittent sound signal warns that the engine is overheating. Signal light (G)
comes on. Switch off the engine immediately and remove the cause of the over-
heating.
P) Area without control device.