2-18
S
ect
io
n
2
IN
STALLATION &
CONNECTI
O
N
ZS-L
User’s Manual
Section 2
Sensor Head
Connecting Sensor Heads
This section describes how to connect Sensor Heads.
Before connecting/disconnecting the Sensor Head, make sure that the Sensor Controller is turned OFF.
The Sensor Controller may break down if the Sensor Controller is connected or disconnected while the
power is ON.
■
Connecting the Sensor Head
Insert the Sensor Head connector into the Sensor Controller until it locks in place.
■
Disconnecting the Sensor Head
Pull out the Sensor Head while pressing in the hooks on both sides of the Sensor Head
connector.
• Do not touch the terminals inside the connector.
• All settings on the Sensor Controller will be cleared if the Sensor Head is replaced with a different
type.
H
LD ON
ZERO
ENABLE
P
L
H
LD ON
ZERO
ENABLE
P
L
Содержание ZS-L -
