Omron V440-F, Руководство пользователя

Страница: 453 / 500

Appendices
M-16 V440-F C-Mount Code Reader User Manual
Bar Code Configuration Mode
can be entered in two different ways:
1
By forcing the reader into
Bar Code Configuration Mode
by serial command
<BCCFG>
.
2
By reading a Data Matrix symbol with a special code word used by ISO/IEC 16022 to signify
reader programming. This can be either in a regular read cycle or during a read rate test.
Reading this symbol in the calibration routine will have no effect.
1
Once
Bar Code Configuration Mode
has been entered, the Data Matrix symbols can be thought of as
serial data. You can configure the reader by printing labels in Omron Microscan’s serial command format.
Commands are processed as if the data were streamed in through the serial port. The reader will
acknowledge the symbol with a green flash, and echo the serial data to the host. If the command
causes the reader to produce more serial output, such as serial verification or counter requests, the
data will be routed to the host port.
Bar Code Configuration Mode
can be exited by any reset
<A>
,
<Z>
or
<J>
command.
The command to exit
Bar Code Configuration Mode
can be included as part of the Data Matrix
symbol. For example, try encoding
<K200,4><K220, 1 ><J>
into a Data Matrix symbol. This configures
the reader to enable
Serial Trigger Mode
, to program a new trigger to end the read cycle, and to exit
Bar Code Configuration Mode
with
<J>
.
Note:
When the system is in barcode configuration mode, 2D symbols are allowed to pass through even
if the reader only has a 1D license. The system outputs a Config Code Received message when the
configuration symbol is decoded instead of showing the configuration symbol’s actual symbol data. A
>
character is output to the Terminal to indicate that the system is ready for bar code configuration mode.
M-9-5 Bar Code Configuration Mode
Definition:
Bar Code Configuration Mode
is a way of programming the reader by
using ECC 200 Data Matrix symbols.
Serial Cmd:
<BCCFG>
1. In normal reading modes, it is required to read a special Data Matrix symbol with a special codeword used by ISO/IEC 16022 to signify
reader programming.