Omron 8U0108-E1-01, Руководство пользователя

Страница: 42 / 333

XtraDrive User Manual Chapter 3: Wiring
3-18
!
Output Signals
Signal Name
Pin
No.
Function Reference
ALM+
ALM- 31
32
Servo alarm: Turns OFF when an error is detected. 5.5.1
/TGON+
/TGON- 27
28
Detection during servomotor rotation: detects
whether the servomotor is rotating at a speed higher
than the motor speed setting. Motor speed detection
can be set via parameter.
5.5.5
/S-RDY+
/S-RDY- 9
30 Servo ready: ON if there is no servo alarm when the
control/main circuit power supply is turned ON.
5.5.6
PAO
/PAO
PBO
/PBO
PCO
/PCO 33(1)
34
35
36
19
20 A phase
signal
B phase
signal
C phase
signal
Converted two-phase pulse (A and
B phase) encoder output signal
and origin pulse (C phase) signal:
RS-422 or the equivalent.
5.2.3
PSO
/PSO 48
49 S phase
signal
With an absolute encoder: outputs
serial data corresponding to the
number of revolutions (RS-422 or
equivalent).
ALO1
ALO2
ALO3 37
38
39(1)
Alarm code output: Outputs 3-bit alarm codes.
Open-collector: 30V and 20mA rating maximum.
5.5.1
TMON 16 Analog monitor signal
Common
VTG
17 Analog monitor signal
Speed
/V-CMP+
/V-CMP- 25
26
Speed coincidence (output in Speed Control Mode):
detects whether the motor speed is within the
setting range and if it matches the reference speed
value.
5.5.4
Position
/COIN+
/COIN- 25
26
Positioning completed (output in Position Control
Mode): turns ON when the number of error pulses
reaches the value set. The setting is the number of
error pulses set in reference units (input pulse units
defined by the electronic gear).
5.5.3
Not used.
23
24
50
These terminals are not used.
Do not connect relays to these terminals.
—
Note: 1.
Pin numbers in parenthesis () indicate signal grounds.
2.
The functions allocated to /TGON, /S-RDY, and /V-CMP (/COIN) can be changed via parameters.
Functions /CLT, /VCT, /BK, /WARN, and /NEAR signals can also be changed. (See 5.3.4 Output
Circuit Signal Allocation).