OilSafe Advanced Bulk System, Руководство пользователя

Страница: 16 / 44

Lubrication Work Center
16
NOTE:
For tanks with overfill alarms, follow
STEPS 10 - 16
to install your overfill alarm.
STEP 9.
If this is an initial installation, and you ordered your bulk system with an overfill alarm, proceed to
STEP 17.
STEP 10.
To install the alarm on an existing gauge, first install the magnet (provided) on your gauge.
See Figure 9 for Alarm details.
FIGURE 9: Overfill Alarm
STEP 11.
Remove the red locking nut that holds the top of the gauge in place. After you remove the nut, you will be able
to remove the calibration (the plastic tube that shows your tank level) and you should have access to the red
indicator. Pull the indicator off by pulling gently upward.
STEP 12.
Make a mark on the indicator rod ½" from the top. Take the small metal clip (provided) and push it onto the rod
down to the mark. Then push the magnet onto the same rod until it is sitting flush on top of the small metal clip
(you may have to file off any burrs on the end of the rod to fit the magnet onto the rod.)
STEP 13.
Once the clip is installed with the magnet on top of it, you will then reinstall your red indicator. Be sure to use
the new red indicator provided with the alarm and discard the old indicator.
STEP 14.
Install the 9-volt lithium battery into the alarm box.
STEP 15.
Loosen the set screw located on the aluminum ring of your alarm. Slide the ring over the calibration down to the
center line level where you wish the alarm to activate and tighten the set screw to hold the alarm in place.
STEP 16.
The switch located on the alarm can be used to silence the audible alarm (where fitted) after it goes off. It will
automatically reset to re-alarm when the magnet moves back out of the alarm area. The switch can also be used
to test the battery. Toggle it once to activate it and once moreto reset it.
IMPORTANT:
•
The Switch is a toggle switch. It is meant to be moved left and right.
DO NOT push down on the toggle switch
.