Ohmeda Ohio Care Plus, Руководство по эксплуатации и обслуживанию

Страница: 65 / 84

7-3
7/Service Procedures
7-3
6600-0239-000 100
Symptom Possible cause(s) Recommended action(s)
HHHH or LLLL appears Patient probe jack Plug the patient probe
in the patient temperature not properly seated completely into the
display in the air control controller.
mode
Patient probe failure Replace the probe and
check the patient.
Alarm cannot be silenced Microprocessor failure Discontinue use and call
and all indicators are for service.
extinguished
System failure alarm Electrical failure Note the error code and
switch off the unit. Wait ten
seconds and switch the
unit back on. If the system
failure alarm recurs,
discontinue use and call
for service.
Probe failure alarm Air probe disconnected in Reconnect the air
either mode. Air temp. temperature sensor
display reads 00.0
Patient probe disconnected Reconnect the patient
in patient control mode. probe.
Patient temp. display reads
HHHH
Patient probe malfunction Replace the patient probe.
in patient control mode.
Patient temp. display reads
HHHH
Control unit failure Discontinue use and call
for service.
Air circulation alarm Blower motor failure Discontinue use and call
for service.
Missing fan Reinstall fan
Power failure alarm The power cord is not Plug the power cord in.
plugged into a live power
outlet
The power cord is not
plugged into the controller
One or more indicators fail Electrical failure Discontinue use and call
for service.
Improper or no Disconnected RS-232 Reconnect RS-232 cable.
Serial String cable