Ohmeda Ohio Care Plus, Руководство по эксплуатации и обслуживанию

Страница: 64 / 84

7-2
7/Service Procedures
7-2
6600-0239-000 100
Service maintenance
This schedule lists the minimum frequencies. Always follow hospital and local
regulations for required frequencies.
Per hospital protocol
Perform the electrical safety and checkout procedure from the Service Manual.
Annually
Check the calibration as detailed in the Service Manual. If possible verify an
acceptable sound level within the infant compartment.
Every Two Years
Replace the battery. Inspect all seals and gaskets. Replace shock mounts and
bushings.
Note: The battery is used to sound the power failure alarm and to power memory
circuits during a power failure.
Troubleshooting incubator problems
WARNINGS Excessive EMI levels in the hospital environment can trigger the system
failure alarm. Note the error code and switch off the unit. Wait ten seconds
and switch the unit back on. If the system failure alarm recurs, remove the
incubator from use.
If an alarm is silenced, closely monitor the patient.
Symptom Possible cause(s) Recommended action(s)
Controller does not Power is off or the power Connect the power cord.
energize cord is disconnected
Switch the power on.
Unit will not heat in Probe temperature Warm probe above 30°C
Patient Control Mode below 30°C
All LEDs go out while Open circuit breaker For controllers with serial
the unit is in use numbers beginning with
HBJ and HCE, discontinue
use and call for service.
For all other controllers,
switch the power Off and
On to reset the unit. After
the second occurrence,
discontinue use and call
for service.
Mode control, Switches are not enabled Press the Enable switch to
temperature switches (enable indicator is out) activate the switches.
( ? and M ), or Override
switches do not respond Controller failure Discontinue use and call
for service.