Ohmeda Ohio Care Plus, Руководство по эксплуатации и обслуживанию

Страница: 57 / 84

6-3
6/Maintaining the Incubator
6-3
6600-0239-000 100
8. Remove the inner wall from the door by pulling out the plunger portion of the inner
wall fasteners as shown in the Figure 6-2 detail.
CAUTION Inner wall fasteners are permanently attached to the inner wall and cannot be
removed without damaging them.
Figure 6-2
Removing the inner wall
9. On double-walled units, remove the inner wall. Lift up the hood while pressing the
hood tilt release. Push the hood back until it locks in the tilted position with an
audible click. Remove the upper and rear inner walls by pulling out the plunger
portion of the inner wall fasteners as shown in Figure 6-2.
10. Lift out the mattress and the mattress tray (Figure 6-4).
11. Remove each tilt assembly by pulling up on the tilt handle. The assemblies will
slide out of their retaining sockets as shown in Figure 6-4.
a For units with the continuous tilt feature, to remove the tilt assembly as shown
in Figure 6-3:
• Pull up the latch on the tilt knob assembly, and swing it out away from the
incubator.
• Grasp the actuator rod and lift the bed lifter/actuator rod assembly straight
up to remove it.
Hole
Plugs
Hood Tilt
Release
Mounting Post
Plunger
Inner Wall
Pull out
Plunger
to Remove
Detail of Captive Fastener
CI.02.071
CI.02.070
Single Walled Unit
Mounting
Posts
CI.02.050
Upper
Inner Wall
Captive
Fasteners
Rear
Inner Wall
Double Walled Unit