Ohmeda Ohio Care Plus, Руководство по эксплуатации и обслуживанию

Страница: 44 / 84

5-8
5/Using the Incubator
5-8
6600-0239-000 100
Power failure alarm
The incubator is switched on, but it is not getting any power.
1. Make sure that one end of the power cord is plugged into the controller and that
the other end of the cord is plugged into a power outlet.
2. Plug another device into the outlet to verify that the power outlet has power.
3. Replace the power cord.
4. If the alarm continues, stop using the incubator and call for service.
System failure alarm
Excessive EMI levels in the hospital environment can trigger the system failure alarm.
Note the error code and switch off the unit. Wait ten seconds and switch the unit back
on. If the system failure alarm recurs, remove the incubator from use. Then, call for
service.
Additional operating procedures
This section provides more information on opening the hood, using the humidifier, and
administering oxygen.
Accessing the patient
Opening the front door:
Opening the front door gives you total access to the patient without affecting the air
flow. To lower the door, rotate the door latches toward the center of the
incubator (Figure 5-3).
WARNINGS Do not leave the infant unattended while the front door or the portholes are
open.
When opening or closing the front door or the portholes, make sure that the
infant, any clothing, the monitoring leads, etc., are completely within the
confines of the bed.
Opening the porthole:
To open a porthole, press in on the latch until the porthole opens. To close a porthole,
push the cover shut until the latch clicks into position.