Ohmeda Ohio Care Plus, Руководство по эксплуатации и обслуживанию

Страница: 58 / 84

6-4
6/Maintaining the Incubator
6-4
6600-0239-000 100
To re-assemble:
• Place the bed lifter back into the the slots in the platform cover.
• Insert the actuator rod in the hole in the back of the platform cover, then place the
other end of the rod in the slot at the front of the cover.
• Allow the bed lifter/actuator rod assembly to slide down until it lies flat in the cover
platform.
• Make sure the tilt knob is rotated down to the lowest tilt position.
• Swing the tilt knob assembly back against the incubator and lock it in position by
pushing down the latch.
Figure 6-3
Disassembling the continuous tilt components
12. Lift out the base platform cover.
13. Remove the humidifier. Slide the humidifier out from under the base. For servo-
controlled humidifier disassembly, see the Servo-controlled humidifier O&M
manual (6600-0223-000).
14. To remove the disposable cuffs, open the porthole and slip the elastic band out
from under the outer ring on the housing. Discard disposable cuffs.
15. Remove the seals on the portholes.
Reverse the steps for assembly. Replace the porthole seals. To install new arm
cuffs, slip the larger elastic ring over the housing of the porthole. To reattach the
inner wall, align the inner wall fasteners with the mating mounting posts and push
in the plunger portion of the fastener.
CI.02.217
Bed Lifter
Tilt Knob
Assembly
Actuator Rod