nStor NexStor 4700S Series, Руководство пользователя

Страница: 39 / 110

Chapter 3 - Setup and Installation
Installing the Enclosure into the Tower Stand
27
Installing the Enclosure into the Tower Stand
1 Remove the storage system from its shipping carton and inspect for obvious
damage.
a Remove and open the accessory kit. Inside you will find the power
cable(s), serial communication cable, and the documentation/software
CD. Also you will find a QuickStart instruction page that provides
accelerated procedures to setup the enclosure.
b Open the left and right flaps on the Accessory Box Insert. Remove the
bezel and mounting rail kit.
c Lift the Foam Pad from the Drive Tray and remove the disk drives from
the Foam Drive Tray. Then remove the Drive Tray from the box.
d
Remove the top foam piece from the enclosure chassis and lift the
enclosure from the box. Place the enclosure on a flat work surface.
2 Remove the power supplies.
Grasp the power supply handle and slide the release latch to the right with
your thumb as you pull the power supply from the enclosure. Repeat for the
other power supply, if installed.
3 Remove the cooling fan module.
Place your finger in the handle and slide the release latch to the right with
your thumb while pulling it from the enclosure.
4 Remove the tower stand case from its shipping carton and inspect for
obvious damage.
5 Locate the accessory kit in the tower shipping carton. It should contain eight
10-32 pan head screws and conversion instructions. (The conversion
instructions enclosed in the box are applicable to converting an existing rack
mount installation to a deskside tower system.)
6 Rotate the enclosure chassis so that the power supply bays are on the top.
7
Carefully slide the enclosure chassis into the tower stand until it fits flush as
indicated by (A) in the illustration on the following page.
8 Secure the top and bottom front mounting ears to the tower stand using two
each 10-32 pan head screws as indicated by (B) in the illustration on the
following page.
9 Install the rear mounting rails into the slots at the rear of the chassis as
indicated by (C) in the illustration on the following page.
4700S.book Page 27 Wednesday, April 6, 2005 2:14 PM