NSK MEGATORQUE M-ESA-J0002V25, Руководство пользователя

Страница: 204 / 294

— 12-5 —
12.2. Glossary
l
This section provides description and specifications of commands and parameters.
l
“Shipping set” denotes a value which is set at the factory before shipment.
l
“Default” denotes a value which is adopted when entering a command and parameter with no data.
For example, if you input “DC” only, it will be recognized and executed as “DC0,” because the
default set of the “DC” command data is 0. If the command does not have a default set, then you
cannot execute the command without data.
l
The password must be entered before inputting a command marked with
«
. Refer to “7.2.1.
Password” for more details.
«
AB : I/O polarity
Format : AB n1 n2 n3 n4 n5 n6 n7 n8
Data : nn = 0 A contact (Normally open)
nn = 1 B contact (Normally close)
nn = X
◊
At the time of input:
The port set to X cannot change polarity.
◊
At the time of readout:
For the port which is shown as “X”, the polarity cannot
be change.
(Fixed to A contact.)
Shipping set : X0X0XX00 (all A contacts)
Default : Not available. Input all 8 digits.
l
Sets the polarity of input command port.
l
The ports of which polarity can be changed are EMST, HLS, OTP and OTM. The other ports are
fixed to A contact.
l
Set “X” for the port of which polarity cannot be changed. If “0” or “1” is input, the display shows
“?” indicating a faulty input.
l
Polarity setting can be read by “TS” or “?AB” command.
l
The table below shows the data and port.
Data digit n1 n2 n3 n4 n5 n6 n7 n8
CN2 pin No.
25 12 24 11 23 10 22 9
Signal name
SVON EMST IOFF HLS HOS CLR OTM OTP
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com