Nortel Meridian Companion, Руководство по установке и обслуживанию

Страница: 99 / 218

Programming the Meridian Companion system Page 89 of 206
Meridian Companion Installation and Maintenance Guide
1. Press
ƒ••‚
and enter the Installer password.
2. From
A. Configuration
, press
^
. The display shows
1. Telephony Data
.
3. Press
*
. The display shows
2. Mobility Data
.
4. Press
^
then
*
until the display shows
System LID: xxxx
.
5. Press
CHANGE
to change the LID.
6. Enter the new system LID.
Note: To enter 1, 4, 5, 6, 7, 8, 9, or 0, press the corresponding dialpad
button. To enter A, B, C, D, E, F, 2, or 3, press the dialpad button
indicated in the following table until the desired character is
displayed.
7. When you have entered the desired character, press
-->
to move the
cursor to the next character position.
8. Repeat steps 6 and 7 until four characters have been entered.
To correct a character, press
<--
or
-->
to move the cursor to the desired
position, then repeat step 6.
9. Press
OK
. If the LID entered is valid, the display shows
LID changed
,
then
System LID:
followed by the new System LID.
Character Dialpad button Press
A
¤
once
B
¤
twice
C
¤
three times
2
¤
four times
D
‹
once
E
‹
twice
F
‹
three times
3
‹
four times