Nortel Meridian Companion, Руководство по установке и обслуживанию

Страница: 89 / 218

Programming the Meridian Companion system Page 79 of 206
Meridian Companion Installation and Maintenance Guide
3. Press
CLEAR
to clear the alarm.
4. Call the system support representative to report the alarm message
Verifying card status
Before performing any programming, it is important to verify that all cards are
present on the system at the expected location. Use the following procedure to
search through all card slot addresses pertinent to the Meridian Companion
cards installed on the system.
1. Press
ƒ••‚
and enter the Installer password.
2. From
A.Configuration
, press
*
until the display shows
C.Maintenance
.
3. Press
^
then
*
until the display shows
2. Card Status
.
4. Press
^
. The display shows
Show card
.
5. You can enter a number or press
^
to see the first card. The
display shows
Cnn:
followed by the card type: CMCC , CMRC , CMLC , or
CMBC
.
6. Press
STATE
.
7. Press
*
to search through all slots, verifying that all cards are
idle as described in “Card Status” on page 128.
8. Follow diagnostic procedures as necessary.
Note: The CMBC must have at least one powered Base Station connected for
the system to recognize it.