Nortel Meridian Companion, Руководство по установке и обслуживанию

Страница: 163 / 218

Maintenance Page 153 of 206
Meridian Companion Installation and Maintenance Guide
13. Enter a Maintenance programming session, reenable the system, and
press
®
to exit.
Once the enabling is complete, the Administration Terminal will display
one of the following:
— a
Config warning
message
— System online
— a
Config failure
message
14. Follow the instructions described in the paragraph that relates to the
message displayed.
a. A configuration warning message is normal, and is accompanied by
two options, RESET and RESUME . If M1 programming and rewiring
are complete, press
RESUME
.
b.
System online
appears if the M1 reprogramming and rewiring has
been into a new IPE Module and the cards are occupying exactly the
same slots as in the previous module. No action is required; proceed
to step 19.
c. The configuration failure message indicates that the cards have not
been installed correctly (that is, in their original order). Repeat steps
9 through 12.
15. After pressing
RESUME
, you will see
System startup
, followed by
System online
. If Base Stations have not been properly reconnected
to the new card slot and TCM device positions, a
Re-Eval required
message displays. Follow these steps:
a. Clear the alarm message (see “Responding to event and alarm
messages” on page 139).
b. Rewire as necessary.
c. Restart the system.
Note: Auto Administration does not report missing Base Stations,
only those that have been relocated to a different address. Even
if the
Re-Eval required message does not display, it is
important to proceed with the next two verification steps.