Nortel Call Recording, Руководство пользователя, Страница: 56 / 94

Test and Debug Capabilities Standard 1.0
56 Nortel Call Recording Card
In addition, if the IXP encounters any failures during its initialization, an
H:XX error code displays. The list of error codes is shown in Table 13:
“HEX display error codes,” on page 56:
Table 13:
HEX display error codes
You can also use the RS232 port to monitor the progress of self tests.
Messages indicating the completion of each self test phase, as well as any
detected faults are printed to this port. Support is provided for boundary
scan and access to the boundary scan interface on the FPGAs.
Status LED
A single red LED on the faceplate indicates the enabled / disabled status of
the card, and indicates the power status on self test.
The LED is OFF if:
„
the channel capacity of the card is not zero
and
Code Code description
H:00 IXP1200 not booting
H:01 SDRAM test failure
H:02 SRAM test failure
H:04 PCMCIA device failure
H:08 Network interface failure
H:10 Meridian interface failure
H:20 DSP interface failure
H:40 NVRAM/EEPROM interface failure
H:80 PCM connector failure