Nortel 5100 Series Release 2.3.3, Руководство пользователя и справочник команд, Страница: 27 / 430

Nortel Switched Firewall 2.3.3 User’s Guide and Command Reference
Introduction
„
27
213455-L, October 2005
†
Check Point SMART Client software, such as the SmartDashboard, can be installed
on one or more administrator workstations on your network. This software usually
provides a graphical user interface for creating, modifying, and monitoring firewall
policies. For security, SMART Clients do not interact directly with the firewalls.
Instead, any policy changes made in a SMART Client are forwarded to the
SmartCenter Server, which then loads them onto the firewalls. For convenience, a
SMART Client can be installed on the management station running the SmartCenter
Server (see
Note – below).
„ Check Point SmartCenter Server management station
The management station running the SmartCenter Server holds the master policy database
for all the firewalls in your network. Its job is to establish Secure Internal
Communications (SIC) with each valid firewall and load the firewall with the appropriate
security policies. The SmartCenter Server may be enabled on the firewall in the CLI setup
utility.
N
OTE
– If you have a second firewall in the cluster to implement an active-standby (high
availability) or active-active firewall configuration, you must install the SmartCenter Server on
a management station. In this case do not enable the SmartCenter Server on the firewall when
prompted in
Step 12 of the initial setup routine which starts on page 37 .