20
INDUSTRY
Section 3
General information and safety regulations
The removal of the signs or their non-replacement
in the event of deterioration means the user takes
on full liability for all the consequences that may
arise or derive from the use of the BLASTER CHILL-
ER due to non-compliance with the safety condi-
tions foreseen by the manufacturer.
This symbol tells you that it is not
possible to use water, or water/foam
extinguishers to put out fires on
electrical equipment.
This symbol tells you that it is not
allowed to carry out work on live
systems, touch systems if not author-
ised, remove the safety guards and
casings before having disconnected
the voltage.
This symbol tells you that it is not
allowed to remove the safety devices
and protections installed.
This symbol warns of the danger of
hot surfaces close to surfaces where it
is attached. In our case this symbol is
attached to the outside of the chilling
cabinet but actually refers to the
surfaces inside.
This symbol warns of a low tempera-
ture hazard. Also in this case the
symbol is attached to the outside of
the chilling cabinet but actually refers
to the surfaces inside.
WARNING!
This symbol warns of a slipping
hazard due to the chilling cabinet floor
that may be icy or slippery.
This symbol identifies a live electrical
system.
This symbol identifies door opening
by pushing on the side on which it is
attached.
This symbol warns of a cutting hazard
and it is attached close to the
condensing unit and to the inside of
the evaporator.
Hazard warning signs have been attached to the
machine in order to highlight the areas of the BLAST
CHILLER where particular attention must be paid and
the areas with residual risk for the safety of the operator
and exposed persons.
3.8
Hazard warning signs
