40
INDUSTRY
Section 4
Installation
Never stand under suspended loads.
Never use two lifting devices at the same time.
If using steel ropes for positioning, be careful not
to create extreme bends.
The maximum weight that can be lifted by an adult
male is 25 kg and an adult female 20 kg, heavier
loads could lead to musculoskeletal problems.
WARNING!
Before removing the blast chiller from the packaging,
check that it is intact, notifying and writing any damage
found on the carrier's delivery note before signing it.
Take photographs of any external damage.
Proceed with the removal of the protective transport
casing and the protective sheets of the steel parts, taking
due care not to damage or scratch the blast chiller.
Do not leave any of the packaging within the reach
of children or animals as it could pose a danger (suffoca-
tion, cutting).Packing components must be disposed of
in compliance with the regulations in force in the country
where the machine/partly-completed machinery is used
and must not be dispersed in the environment.
After removing the packaging, make sure the appliance
is intact; if it is damaged, promptly notify the retailer or
manufacturer. If the damage is such as to compromise
the safety or functionality of the machine, do not proceed
with the installation until a qualified technician has been
called out.
Operators must also wear personal protective equip-
ment. The personal protective equipment required in
these phases is:
•
•
•
•
The machine/partly-completed machinery must be
installed and tested in full compliance with the accident
prevention laws in force in the country of use of the
machine/partly-completed machinery. For safety
reasons, all the operations of handling and positioning
of the machine/partly-completed machinery must be
performed by qualified technicians.
The installer must verify any restrictions imposed by
local authorities and regulations.
The personal protective equipment required in this
phase is:
4.6.2 POSITIONING
For proper installation of the blast chiller with air
condensing unit built into the machine compartment it
is necessary to check that in the installation area there
are no obstructions of the inlet and outlet air vents. Any
blockage of the air inlets compromises the correct oper-
ation of the machine/partly completed machinery.
It is also necessary to maintain a service area in the
front part of the blast chiller and minimum distances
between the latter and the surrounding surfaces in
order to guarantee a correct air flow and avoid conden-
sation formation (see drawings).
4.6.2.1 POSITIONING OF THE UNIBODY
BLAST CHILLER OR CHILLING CABINET
