Norcold 121X series, Руководство по обслуживанию

Страница: 71 / 100

S
ection
8
69
For steps 11 through 15 refer to Figure 8-5
on page 70 .
11. Remove wire ties that hold wire protector to
cooling unit plug.
12. Remove permagum sealer from drain hose
opening. Save for reinstallation.
13. Cut the tape along the four edges of the
cooling unit back wrapper.
14. Remove condenser bracket screws (2).
15. Remove absorber bracket screws (2).
16. Lift absorber coil just enough to move wiring
and ice maker water line (if present) out to
the side of the cabinet.
Use only NORCOLD approved Thermal
Mastic sealant (part number 61450740).
Do not use silicon, latex or petroleum base
sealant. Silicone, latex and petroleum-
sealants may damage the cabinet and/or
cooling system foam plug, greatly reducing
cooling efficiency.
CAUTION
Applying Thermal Mastic Sealant
Sealing the cooling unit to the cabinet requires
all three tubes of Thermal Mastic sealant
supplied with the replacement cooling unit.
Each tube tip must be cut wide to dispense
a bead approximately no wider than 3/4 inch
wide.
Apply the sealant as outlined in the
following steps. Failure to apply the sealant
as outlined will result in poor cooling
performance.

IMPORTANT

1. Apply a 3/4 inch wide x 1/2 inch thick bead
of Thermal Mastic sealant to the evaporator
section of the cooling system as shown in
Figure 8-6, page 71.
2. Apply 3/4 inch wide x 1/2 inch thick bead of
Thermal Mastic sealant on the four sides of
the cabinet opening. See Figure 8-7, page
71.
17. With the help of an able person lift the cooing
unit out of the cabinet.
18. Remove all thermal sealant from the cabinet
steps and freezer plates.
19. Remove all thermal sealant from the
evaporator coils and plug.
WARNING
Do not attempt to pull the cooling unit out
of the enclosure without the assistance
of an able person. Attempting to pull the
cooling unit without additional help may
cause personal injury and/or extensive
property damage.