Norcold 121X series, Руководство по обслуживанию

Страница: 54 / 100

52
S
ection
6
Pull to remove
Push until the end of casing
is flush with flange opening
Figure 6-10. —Spring pins and cabinet contacts.
Figure 6-11. —Removable door seal heater spring pin removal and installation.
A jammed, bent or broken spring pin has to
be replaced to maintain the flapper assembly
heater working.
To replace spring pin see Figure 6-11 and
proceed as follows.
1. Open the left fresh food compartment door.
2. Pull out the existing spring pin from the
flange.
3. Push and seat the replacement spring pin
into the contact flange.
4. Check spring pin operation.
a. Push the pin all the way until seated then
release.
b. Spring pressure should extend the pin
fully when the contact is released.
Left door - hinge side
Contact point on cabinet
Spring pins
Do not attempt to remove the spring pin
flange from door! The flange is not a
replaceable part. Attempting to remove
the flange will disconnect the wires
from the pins housing resulting in door
replacement.
CAUTION
Spring pin replacement