D-F10137 NP-2651/3651 Product Spec. Rev.0.01(Provisional)
11
[How to Change the paper width of NP-3611 from 80mm to 76mm]
(Only right side when viewing from paper out let side of printer)
Before change paper width
80mm(Default setting)
Move guide, arm, and shaft.
Remove paper table.
*Please turn OFF power supply
.
(1)Move guide. Remove paper table.
*Please beware of no floating or no bending of guide and no
loosening Screw.
(2)Move Arm
*Self-tapping screws(M4) are used. When attaching to new holes, you may feel heavy to turn drivers.
*Please remove clamp once and attach the same direction and position shown as pictures.
(3)Move core
*Please beware of no floating or bending of guide and no loosening Screw.
After change Paper width 76mm
[Note]
・
When paper width 80mm, the side to attach arm is changeable. Please refer to (2).
Guide
Shaft
Arm
Paper
Table
Shaft
Loosen screws.
(Until screw head float like
1mm)+roundheadscrews(B
tight)M2.6
Move shaft to the arm side
for one chase with holding
up the spring.
Fix it(1 place)
Move for one chase
Arm
After move
Before moving
Interspace
Please move guide at the
position of picture, hold it,
and fix it(1 place)
+roundheadscrewM2x4
N 0
No paper table
Set boss.
(No Float)
Remove screws(1 place)
+roundheadscrewsM2x4No0
Keep thermal head cover
open
Guide
Paper table
(Remove it when
moving guide)
Bosshole for76mm.
Attachment hole
Attach at the opposite
side.(Before attachment)
Remove screws(4
screws
CN6(3pin)
Take it from the hole on plate
Remove near end cable
Tighten with
clamp
Arm
Insert from hole on plate
Attach near end
cable
CN6 (3pin)
Fix (4 places)
Bottom side view
Bottom side view
Hole on plate
