D-F10137 NP-2651/3651 Product Spec. Rev.0.01(Provisional)
12
2.4 Cutter Specifications
Symbol
Description
Dimensions
A
Partial cut A remaining tab
1.0
～
2.5mm
B
Cut~Print Head Position
9.5±1mm
C
Back feed limit
6.5mm
D
Paper edge (1dot~) to partial cut
remaining tab center distance.
30±0.5mm(NP-2651)
40±0.5mm(NP-3651)
[Note]
*D dimension does not change even if paper width changed to 60mm with NP-2651.
*D dimension does not change even if paper width changed to 76mm with NP-3651.
1) Cutting Method
：
Slide System
2) Cutting Mode
：
Full Cut / Partial Cut A / Partial Cut B
[Note]
*Selectable by command
*Partial Cut B remains larger tab amount than Partial Cut A.
3) Allowance of cutting Frequency
：
30 cuts/minute(1 cut / 2 seconds).
4) ) Paper Thickness
：
154μm
or less
[Note]
* In case Partial Cut B is conducted with the paper thickness of 75μm or thicker, there may be a
case that paper is drawn from mechanism side at the time of tear off paper.
5) Minimum Cutting Length
：
30mm
[Note]
・
When conducting something that may overload to the platen such as strongly pulling out paper
after partial cut etc. Please be aware there is a possibility that beginning of the next print line
may crash.
・
Please feed paper for more than approx. 1mm (8 dot line) in order to prevent crash of print line
head when printing after partial cut operation.
・
Please cut off paper after partial cut by pulling paper laterally toward the side of nipping cut-
paper edge either left or right side in order not to load platen.
・
Above B size becomes11.5±1mm since approx.2mm paper feed is activated automatically to
prevent paper jam after cutting.
・
Please refrain from using to generate chaff by cut. It will be a cause for paper jam.
・
When the blade for partial and full cutting, paper bloom may be generated .
・
There is a case full cut paper may not fall.
Feed Direction
C
Cutting Position
Print Head Position
A
Print Surface
B
Back Feed Limit
D
