D-F10137 NP-2651/3651 Product Spec. Rev.0.01(Provisional)
40
2) Setting paper by auto-loading function. (Recommendation)
(Recommended when other paper is set)
(1)Please set roll paper to paper holder
(2) Please insert paper edge into paper entrance.
(Please make sure roll paper will be inserted straightly along paper insert guide.)
(If there is a tape on paper front edge, please peel off and straightly, vertically cut the paper
until peel-off signature with scissors.)
(3) Paper sensor will detect paper and paper is automatically pulled, level detection
movement is started.
(Please make sure thermal head cover is closed.)
(Please make sure switch ON)
(4) Printing will be ready after completion of level detection movement.
[Note]
・
Please remove the old core before setting new roll paper.
・
Please set paper with no loosening (It causes paper jam)
・
Please set paper front edge straightly and at a right angle
(Please refer to Fig. of paper front edge shape).
・
When inserting a roll paper front edge with fracturing or diagonal cut, it may disable pull-in
movement.
・
If there is a tape on paper front edge, peel off and vertically/straightly cut the paper to peel-off
trace with scissors.
・
The print side must be external side and also it must be upward to insert.
・
In the incident of inserted paper on the bias, open the head cover and straighten the paper.
(Please do not apply extra force beyond the stop position when opening a thermal head cover,,
and please do not get your hands and fingers caught.)
・
Since thermal head may be highly-heated right after printing, please do not touch it.
・
Please make sure to conduct auto-loading after conducting setting command for label when
using different paper. Please refer to command reference for command.
Paper edge form
Label 1
Label 2
×
Label 1
×
Label 1
Label 2
○
Paper entrance
Tension Roller
