Nippon Primex NP-2651, Технические характеристики

Страница: 37 / 51

D-F10137 NP-2651/3651 Product Spec. Rev.0.01(Provisional)
30
4.2 Error Handling
1) Details of Error Detection
Alarm
*1
Status
Name Status
Data
Receivi
ng
Status
Information
How to handle
- Communication 232C communication error Enable - Adjust
Error Parity communication
Overrun condition
Framing
OFF Normal Normal condition Enable bit0-7“0”
OFF Print Start Print start setting by command Enable bit7 “1” Print end setting
Status (not error) by command
Blink Paper detection Not detecting gap by label Disable bit5“1” Open thermal head
cover to
error transmission sensor
remove paper,
then close
thermal head
cover.*2
Blink Auto-cutter
Abnormality Cutter paper Jam Disable
bit4“1”
Open thermal head
cover and
close after
remove error
factor*2
Blink Head temperature In case head temperature gets Disable bit3“1” Auto recovery at
Abnormality
approx.70
℃
or more approx.65
℃
Head temperature
ON Paper end Paper-out Disable bit2“1” Paper replenishment
ON Thermal head cover
open
Thermal head cover open Disable
bit1“1”
Thermal head cover
close
Blink 1 Paper near end Remaining paper detect Enable bit0“1” Paper replenishment
Paper near empty sensor
detection
(MS2-4:OFF)
[Note]
・
When the above errors are detected (except communication error, paper near end and print start
status), printer stops all operations. (Print operation and paper feeding by FEED switch are
unavailable too).
・
Auto-loading is not activated when detecting the above errors except for “Paper near end”,
“Paper end” and “Print start status”.
・
Turns ON(“1”) error bit of the status information.
In case of replenishing paper by auto-loading, automatic level detection is activated.
・
After release of paper end, activates a full cut movement after auto-loading paper.
・
When platen-open is released, activates a full cut of paper after paper feeding.
*1
：
Please refer to [4.6 Alarm Lamp Display and Switch function Operation Panel] for the display
pattern of alarm lamp.
*2
：
In case glue adhere to head or cover, etc., please refer how to maintenance and clean.
4.3 Buffer Full Print
Printer at time of receiving data for 1 line
*1
automatically activate print linefeed based on the
command [LineFeed Amount Setting of the Smallest Paper Feed Pitch ] < ESC 3 n >
*1 Buffer full data number(Maximum print digit number) differ depending on each size of
ANK
・
Japanese Kanji (Please refer to [2.1.2 Print specifications]).