D-F10137 NP-2651/3651 Product Spec. Rev.0.01(Provisional)
37
(2) Precaution for cut operation
・
Please make sure to cut gap part when cutting label paper.
If label part is cut, glues adhere to cutter blade and cause failures.
・
Paper may drop when conducting detection to reverse direction after cutting operation.
Example for dropping is shown below.
[Note]
・
Paper drop since the movement of paper tip which try to return to inside of head position.
This problem occurs with the paper whose gap length is 11.5mm or less. Also, it occurs
even if the gap length is 11.5mm or more depending on cutting position.
・
It is recommended to skip a piece of label paper for gap detection after cutting and conduct
forward detection.
・
Please confirm firmly at user side when detection to reverse direction of gap.with cut.
Cover
Transmission
Sensor
5mm
6.5mm
Cover
Transmission
sensor
Head
ﾗﾍﾞﾙ
3
ｷﾞｬｯﾌﾟ
ﾗﾍﾞﾙ
2
Status after cut operation
10mm
Cutter
ｶｯﾄ位置
Label 1
ｷﾞｬｯﾌﾟ
Tip
Paper Feed
Direction
5mm
6.5mm
Head
Label 3
Gap
Label 2
Status after back feed
Tip
Paper tip
Paper tip should be inside of this line
Paper Feed
Direction
Label 3
Label 2
Gap
Gap
Cutting position
