D-F10137 NP-2651/3651 Product Spec. Rev.0.01(Provisional)
[SAFETY PRECAUTIONS]
Please comply the follows in order to use for many years to come and prevent troubles before happens.
●
Please turn OFF the power before connecting or removing connectors. When disconnecting, handle
with the connector body and please do not pull out by a cable.
●
The product is NOT protected from water or dew drop. Please do not put water to the product nor
handle it with wet hand because it may cause damage, heating, firing by short circuit.
●
In order to prevent excessive current, please add an electrolytic capacitor and a fuse (Please refer to
power supply specifications for details) to external 24V power line.
● Please DO NOT disassemble
or modify the product.
● In case of disposal, please follow the regulations or rules of the local authorities.
● Recommend a power supply in conformity with LPS standard.
● Please turn OFF the power when not using for a long time.
● Regardless of duri
ng movement or stop of the cutter, please do not touch the cutter blade.
[QUALITY PRECAUTIONS]
Please comply the following in order to use for many years to come and prevent troubles before
happens.
DATA
● Movement when sending undefined control codes
and commands to the product is not guaranteed.
●
Since the print feed may jumble between the first 1 – 4 dot lines with such a print program that the
print and paper feed gets interrupted temporarily in state of printer’s data queuing from the host device,
please be cautious when graphics and the like are included in the print data.
PRINT MOVEMENT
● The print may jumble at the first 1
-2 dot right after the paper cut action.
● Please do not touch the heating element part of the thermal head, since it could
degrade the print
quality due to soil.
● In case of using print papers other than those specified in this document, print quality and lifetime of
thermal head may not reach the level guaranteed by the manufacturer.
● Please do not pull out the paper while
the printer is in motion of printing, paper feeding or cutting.
When removing the partially cut paper or perforated paper, pull it to either right or left direction without
too much force.
● Continuous motor running for a long time generates heat and may a
ffect the printer performance. To
avoid the case, it is necessary to limit the continuous motor running time to 6 minutes at maximum
with the same interval time for each operation.
● Motor may produce heat by continuously driving cutter motor for a long ti
me and it may not perform
necessary functions. Please make sure to follow cutter tolerable frequency.
● Please set the paper straightened with no slack.
● A part of this product is made from coated steel plate. It does not affect the product’s quality and
performance at all even if the cut face of the steel plate get rusty after a long time period.
